Scope of application:
In general can be used to heat plastic such as acrylic, ABS, PC, PS, PETG, hard and soft PVC material such as nameplates, signs, etc. have been processed PET.

Features:
J-123 Series system is a high color density, high of hiding (and even printed on a black base material does not change color), particularly good printability of the anti-alcohol, anti-petrol, glue-resistant, wear the high-performance ink, with the in the screen printing or printing fine lines, small text, it is also very good.

Technical parameters:

Test item test conditions the test results
Fineness ≤ 8μm ink scraper fine Meter
Dry gloss gloss meter mirror ≧ 85o 60o
Drying speed dry 25 ℃ × 10-15min or 60 ℃ × 3-5min
Hard work 25 ℃ × 24Hr or 60 ℃ × 15min
Adhesion 100/100 1mm × 1mm × 100 grid 3M adhesive strip
Wear no change 500g / 5 cm2 load Blanket x150 times back and forth
Gasoline resistance unchanged 500g / 5 cm2 load 97 # gasoline cotton x200 times back and forth
Resistance to alcohol-induced no change in 500g / 5 cm2 load 95% alcohol cotton × 200 times back and forth
Acid resistance No change soaked 5% HCl × 24Hr
Alkali resistance unchanged soaked 5% NaOH × 24Hr
Soaked in salt tolerance of no change in 5% NaCl × 24Hr
No change soaking water-resistant water × 96Hr
Shows the basic colors and locations in this series four-color heavy metal content are in line with the EU ROHS, European EN-71Part3 standards and the U.S. ASTM F963-07 standard.



Usage:
a. Please ink before using the full mix evenly, to prevent the ink may have additive effects added to separation.
b. before printing it is necessary to first consider the removal of the surface of printed materials grease and dust.
c. the environmental conditions, depending on the actual selection of the optimal operation of the Company's fast, medium and slow in some sort of three types of diluent.
d. want to print, depending on the actual results, correctly select the proper screen: 77 line -150 lines / cm
e. In order to achieve fine lines, pattern, writing an excellent printing results, you can add the company's J-23-100 temporary condensate paste, printing ink in order to better prevent the spread of glitches, blurred.

Note issues:
a. Please be sure to first test pre-press printing, to prevent differences caused by plastic type not meet the necessary quality requirements.
b. When the printing after the printing process caused by poor or bad attached, please note that most likely Plastics plasticizers or other additives, surface, caused by migration, but also should consider whether electrostatic reasons, the proposed alcohol or white can be used to clean the oil.
c. diluent can be adjusted between 20-30%, depends entirely on the number of mesh mesh, environmental conditions and printing results to adjust the high and low viscosity ink.
d. due to the difference in printing substrate, the corresponding difference will cause dry, press the target to confirm the actual drying method and drying time to ensure that the quality of printed after.
e. the use of the series before and after use ink, the ink containers should be completely sealed and placed in a cool well-ventilated place to save, avoid contact with open flame or high temperature.
f. This series of products from the production date of the shelf-life of 1 year, longer than when you re-confirm availability.

Attached: The patience of the above experimental data-based company's test results under the experimental conditions is not classified as guaranteed value.