Scope of application:
Common metal, alloy, glass products, thermosetting plastics, electroplating, coating, hardening coating, production of a variety of industrial signs, panels, et al.

Features:
J-133 series is up to the main agent and hardener can be used by a certain ratio of the two-component ink curing reaction, which can be naturally dry, dry heat can also be an appropriate response, cured coating has excellent adhesion can be resistance to stamping, bending, and has good chemical resistance.

Technical parameters:

Test item test conditions the test results
Fineness ≤ 8μm ink scraper fine Meter
Curing condition OK 25 ℃ × 48Hr
OK 60 ℃ × 60min
OK 90 ℃ × 30min
OK 120 ℃ × 15min
Drawing pencil hardness of HB China 500g × 45 °
Adhesion 100/100 1mm × 1mm × 100 grid 3M adhesive strip
The impact of non-Yizhuang Ф1 / 2 "× 500g × 50cm
Bending of non-Yizhuang 1.5mm × 180 ° bend
Acid resistance No change soaked 5% HCl × 24Hr
Alkali resistance unchanged soaked 5% NaOH × 24Hr
Soaked in salt tolerance of no change in 5% NaCl × 24Hr
No change soaking water-resistant water × 96Hr
No change in resistance to toluene immersion × 96Hr
The present series a total of 30 basic colors and networks and tailor-made four-color metallic effect color.
This series of basic colors and four-color heavy metal content network are in line with the EU ROHS, Japan, ST and the U.S. ASTM F963-07 standard.



Usage:
a. Please ink before using the full mix evenly, to prevent the ink may have additive effects added to separation.
b. before printing it is necessary to first consider the removal of the surface of printed materials grease and dust.
c. the environmental conditions, depending on the actual selection of the optimal operation of the Company's fast, medium and slow in some sort of three types of diluent.
d. want to print, depending on the actual results, correctly select the proper screen: 77 line -150 lines / cm
e. In order to achieve fine lines, pattern, writing an excellent printing results, you can add the company's J-23-100 temporary condensate paste, printing ink in order to better prevent the spread of glitches, blurred.

Note issues:
a. Please be sure to first test pre-press printing, to prevent differences caused by plastic type not meet the necessary quality requirements.
b. When the printing after the printing process caused by poor or bad attached, please note that most likely Plastics plasticizers or other additives, surface, caused by migration, but also should consider whether electrostatic reasons, the proposed alcohol or white can be used to clean the oil.
c. diluent can be adjusted between 20-30%, depends entirely on the number of mesh mesh, environmental conditions and printing results to adjust the high and low viscosity ink.
d. due to the difference in printing substrate, the corresponding difference will cause dry, press the target to confirm the actual drying method and drying time to ensure that the quality of printed after.
e. the use of the series before and after use ink, the ink containers should be completely sealed and placed in a cool well-ventilated place to save, avoid contact with open flame or high temperature.
f. This series of products from the production date of the shelf-life of 1 year, longer than when you re-confirm availability.

Attached: The patience of the above experimental data-based company's test results under the experimental conditions is not classified as guaranteed value.